Logo

C2606 Engine Code Repair

Meaning of C2606 engine trouble code is a kind of chassis trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

C2606 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for C2606 code is occuring now you should check C2606 repair processes.
Now don't ask yourself; What should you do with C2606 code ?
The solution is here :

C2606 Possible Solution:

C2606 Engine

The firing order is an important part of the overall design of the engine and is determined during the design of the engine to eliminate as much engine vibration as possible. If the firing order is changed or adjusted, the ignition from the spark plug is delivered at the wrong time and the engine functions poorly or does not run. The firing order for a particular engine is typically found in the repair manual specific to that model.

C2606 Code Meaning :

C
OBD-II Diagnostic Chassis (C) Trouble Code For Engine

2
Fuel And Air Metering (Injector Circuit Malfunctions Only)

6
Fuel Composition Sensor Circuit Malfunction

0
Crankshaft Position Sensor A Circuit Malfunction

6
Crankshaft Position Sensor B Circuit Malfunction

Regarding the C2606 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

C2606 OBD-II Diagnostic Chassis (C) Trouble Code Description

C2606 engine trouble code is about Crankshaft Position Sensor B Circuit Malfunction.

Main reason For C2606 Code

The reason of C2606 OBD-II Engine Trouble Code is Fuel Composition Sensor Circuit Malfunction.

C2606 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.